Step by Step Guide on How to Set Up a Mouse Trap

Step by Step Guide on How to Set Up a Mouse Trap

Did you know that over twenty million rodents make their way into American homes every year? This fact can often make people uneasy. And if you’ve recently encountered a mouse in your home, you’re probably already a little on edge.

Luckily, there are several things that you can do in order to make sure that your rodent problems become a thing of the past. And one of the oldest and simplest ways to take care of mice is by using a mouse trap. However, it’s important that you learn the proper way for how to set up a mouse trap so that it actually works and you don’t hurt yourself.

Interested in learning more? If so, then continue reading and we’ll walk you through everything you need to know!

Remove the Mouse Trap Packaging

For most mouse traps, there is usually a staple that holds the snap wire to the woodblock. Make sure to take off this staple so that the snap wire can be pulled back. 

Add Bait to the Trigger

The classic example of bait is cheese. However, mice don’t actually love cheese as much as you think. The ideal food to use here is peanut butter. 

You want to use a bait that’s actually going to stick to the trigger and not just sit on it. You want to put enough peanut butter on the trigger so that it covers it. However, you don’t want to put so much that the mouse can nibble on it without setting the trap off. 

Check to make sure that the peanut butter is stuck to the trigger so that it doesn’t fall off when the mouse tries to eat it. You want the peanut butter to be on the end of the trigger that’s farthest from the trap’s spring. 

It’s a good idea to put a small nut in the peanut butter too. This will encourage the mouse to dig deeper into the peanut butter. 

Set the Mouse Trap

Pull back the snap wire and lay the lock bar on top of it. Slowly lessen your hand pressure that’s holding the snap wire down and let the wire press upward on the lock bar. The baited end of the trigger should lift up and lock the trap into position.

If the lock bar falls off the trigger, then the trap is going to spring. Be very careful with the snap wire and watch your fingers. 

Place the Mouse Trap

Always hold the mouse trap on the end where the lock bar was stapled to the woodblock. Place the trap carefully, with the trigger up against the wall. Then, just wait to catch a mouse. 

It’s important to note that, while this method might take care of a few mice, it won’t solve a more serious rodent issue. If you want to take more powerful measures, then you should contact a pest control service, like Altuspest.com, to solve your mouse problems once and for all. 

The Importance of Knowing How to Set Up a Mouse Trap

By knowing how to set up a mouse trap, you’ll be better prepared to deal with a mouse problem in your home. Just make sure to follow the directions carefully so that you don’t end up hurting yourself or messing up the trap. 

And make sure to check out the rest of our site for more helpful articles!